Tom Speirs

[NEWS] PinballX 2.39 - Pinball Arcade Fixed. FX 3

Recommended Posts

PinballX 2.39

This release has Pinball Arcade working again with the latest version of the software. Ensure to set the interface version as 4 in the Setup Wizard.

Pinball Arcade Camera Mod is now directly supported as the launch target instead of the Pinball Arcade Executable and direct table launch is supported. This is automatically detected if the executable is the camera mod and the -table [TABLEFILE] parameters are used. Ensure that PinballX runs as administrator when trying to use the camera mod. Here is what the settings should like for direct table launch with the camera mod. Otherwise the latest version of Pinball Arcade is supported using grid selection with this release.

[PinballArcade]
WorkingPath=C:\TPAFreeCamMod
Executable=TPAFreeCamMod.exe
Parameters=-table [TABLEFILE]
Process=PinballArcade11.exe

 

Pinball FX is now also forcibly killed for those of you that had to have a launch after to kill the process. This should no longer be required.

Pinball FX 3 release is just over a day away. I don't have access to a Beta but I am told these settings work with the Beta with cabinet support enabled:

[PinballFX2]
WorkingPath=C:\Program Files (x86)\Steam
Executable=steam.exe
Parameters=-applaunch 442120 "-table_[TABLEFILE]"
Process=Pinball FX3.exe

 

 

 

  • Like 3
  • Thanks 1

Share this post


Link to post
Share on other sites

A question regarding FX2 vs FX3. Since not all tables will migrate from FX2 to FX3, will it be possible to have integrated FX3 support in PinballX separate from FX2? 

  • Like 1
  • Thanks 1

Share this post


Link to post
Share on other sites

Feature request submitted - 

 

  • Like 2

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.