rtkiii Posted January 30, 2017 Share Posted January 30, 2017 I cannot seem to get my UltraDMD tables to load in PBX. The tables work fine in VisualPinball but always get a path issue when trying to launch inside of PBX. I have the paths setup like normal VP and VPX tables. I know tables pull information from an additional ultraDMD folder...but again they work fine in VP. Any ideas what I am missing? Thanks, Link to comment Share on other sites More sharing options...
Carny_Priest Posted January 30, 2017 Share Posted January 30, 2017 Install ultraDMD outside of the Program Files folder. All dll with anything in you pinball installation needs to be unblocked. All executables need to be set to run as admin. What message do you get that indicates path issue? Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
rtkiii Posted January 30, 2017 Author Share Posted January 30, 2017 Says error loading the table and gives the path from where it is supposed to be running from. Outside of PBX it works fine. I might have something wrong inside of PBX which is fine but before I dove too far into it I wanted to see if others had success running UMD tables in PinballX. Link to comment Share on other sites More sharing options...
rtkiii Posted February 23, 2017 Author Share Posted February 23, 2017 As Expected...there was a typo in my path Tested fine! Link to comment Share on other sites More sharing options...
Recommended Posts