Search the Community

For some reason when I load tables up via PinballX the BAM settings aren't being used. Once the table is loaded up the table is pushed to the upper left part of the table and not in the default size/position that BAM usually displays the table in. I can run BAM outside of PinballX just fine via FPLoader.exe, load up a table and press Q to get to the BAM settings menu, by default BAM displays the table in the middle of the screen. What it seems like is PinballX isn't even running FPLoader and is just calling Future Pinball.exe essentially not loading any part of BAM or its settings. I did notice something odd though, when I remove /STAYINRAM from the parameters that PinballX will actually load the BAM settings just like if I ran FPLoader outside of PinballX, but PinballX crashes to the task bar and or exits essentially making me have to reload the pinballX application again. So something funky must be going on with the /STAYINRAM but I'm not entirely sure at this point. Future Pinball, FPLoader, and PinBallX are all set to run as Administrator I attached 2 screen shots, my PinballX.ini, and log.txt files. Screen 1 - FP+BAM outside of PinballX: Shows how the table looks and loads up when I run FPLoader outside of Pinballx Screen Shot 2 - FP+BAM inside PinballX: Shows how the table loads up when I run FPLoader in PinballX FP+BAM settings are under [system_2] PinballX.ini: PinballX.ini Log File: log.txt Thanks for any and all help, I have been trying to get this to work for a few weeks and have been pulling my hair out trying to get this to work correcty. BONUS Screenshots of my cab, I am a newb and just got into the hobby about 5 months ago.