producerdc

My apologies, where should I have posted this? Thanks

Pinballx not starting on table/ section where I left off. For example, if I play Twilight zone, exit out of the game it goes back to Twilight zone selection before starting the game, if I shut down the computer and restart the system after booting back up it starts on a totally different game than I left of on. am I missing some sort of setting? Thanks

Thanks fo all the help folks! the kill.bat worked,

I could be theconly people with this problem. it seems that when running pinup player inside of pinbalx, pinup player will not close when I exit the table, but does out side of pinballx, it works fine with vpx 10.6 so im a little confused to what is going on . hope some one can help shed some light on the issue. thanks

log.txt

Dmd showing after I launch table in vpx, this didn't start until after I updated to 5.2. im uses windows 10 and the .ini file reads: AutoPositionPinMAME=False. am i messing something? Thanks for any help PinballX.ini

Guys, Thank you both for your help. What I found that worked was turning all of the programs and components for all of my pinball systems "running as admin" off, All of it works perfectly now, go figure. Thank you you both again for the quick and helpful responses.

This problem may be old news to some of you, but im very new to virtual pinball so im hoping to get some help. Im using Joytokey to map controls to pinball fx2 through Pinballx (runing as administrator). Joytokey works when I launch outside of pinballx, but wont work if i launch through Pinballx. But.... If I turn of "run as administrator" for Pinballx it works fine, but then Visual pinball and future pinball wont work properly through Pinballx. I hope this is a common problem with an equally common solution. any help would be greatly appreciated