What am I missing?
Windows 7
PinballX 2.94
VPX 10.4.0
Win7's Displays are laid out like this left to right - MAIN (1) / BG (3) / DMD (2)
Main Monitor/Playfield = Display 1
BG Monitor = Display 3
DMD Monitor = Display 2
In PinballX settings, if I put the BG on 3 and the DMD on 2, when I launch PinballX they are reversed. The DMD ends up on the bg monitor, and the bg ends up on the dmd monitor. If I quit and go back into settings, and reverse them in settings, then when pinballx is launched they are on the correct screens.
If I set screenres.txt to use bg on 3, and I launch a table manually via VPX, then everything is fine.
If I swap 2/3 in pinballx's settings, so that pinballx displays stuff properly... then start the table via pinballx, pinballx changes screenres.txt so that bg ends up on display 2 resulting in the BG ending up on the wrong monitor when VPX starts.
NOTE:... this same cabinet has been running VP9/Vpinmame/Hyperpin just fine for 2 years. I simply decided to try VPX and PinballX as an alternative, which is saved into a different folder structure leaving the original setup intact.
What can I do?
Thank you.