RCAerobat

Ok, I am having this nudge sensor problem also. Did anyone find an answer for this? My PM5 games have crazy ball movements and are basically unplayable. thanks.

OK, I finally found the culprit. Apparently, I have two B2S setups in my visual pinball folders. I have one in the main visual pinball folder and that one had the correct resolution. Then I decided to look into the other folders and I found a B2S editor under the table folder. When I clicked that one, the resolution was wrong. I put in the correct values and it fits the screen properly again! Yeah! My question is, should I have that B2S editor in both folders? Thanks

Hey guys, I need some help and advise. I have been building my system and have around a hundred different VP games loaded and playing fine (9.91, PM5 and VPX). My next part of this was to setup the front end and I decided to go with PinballX. I am running Windows 7 and everything is still running and playing fine after installation of PinballX, with one exception. The resolution of my back glass display has changed and I can't figure out where the change has happened. I set the resolution in the setup of PinballX to match what was on the monitor, but now it doesn't fit on the screen vertically (it's cut off at the bottom) and there is a black bar on the right side. The monitor is set at 1366x768. I am running a B2S server for the back glasses. Help! It's not a big deal, but it's just aggravating. Also, I haven't yet started to load the games using the game manager. Is it difficult to point the different games to the correct version of VP (9.91, PM5 and VPX)? thanks again!